PN: 785A Plating Cell with Flow Holes

$185.00

The Plating Cell PN:  785A  is made of Poly-carbonate Construction and is to be used in a plating tank or can be used in a laboratory with the PN:  100 Container.

Note: Not recommended for Chrome plating

SKU: 785A Category:

Description

Cell P/N Lexan PVC Open Bottom Pump Max °F Volume Lab setting In-tank
785A Yes No Yes No 212 1/2 Gal. No Yes
785B  No Yes Yes No 360 1/2 Gal. No Yes
785C Yes  No No No 212 1/2 Gal. Yes No
800L Yes  No No Yes 212 1 Gal. Yes No
800PVC  No Yes No No 360 1 Gal. Yes No
492  No Yes  Yes  No 180 400 Milliliters Yes Yes

 

The plating cell PN:  785A  is made of Poly-carbonate Construction and is to be used in a plating tank or can be used in a laboratory with the PN:  100 Container.  The cell offers a standard geometry with respect to anode size and positioning.  Consistent anode to cathode spacing is maintained.

NOTE: During plating a test strip is exposed to a uniform current density along the legs of the strip.  The plating test should be continued until the test strip legs deflect up to 20 units and with a target thickness that does not exceed approximately 100 microinches for the most accurate results.  Very low stress may show only 1-2 units.

Plating Cell PN:  785A Features:

* Handles for holding the cell in a working tank

* Has side flow holes for in-tank use

* Can be used in a lab setting if used in conjunction with the PN: 100 Container

* Two anode pockets for 2 3/8″ (61 mm) x 2 3/8″ (61 mm) anodes

* Leads to each anode from a central contact

* A clip assembly for positioning the test strip midway between the anodes

* The cell does not accommodate our heater or pump

Not recommended for Chrome plating

 

Additional information

Weight 4 lbs
Dimensions 9 x 4 x 7 in

You may also like…