PN: 800L Plating Cell Poly-carbonate (two compartment)


SKU: 800L Category:


Cell P/N Lexan PVC Flow Holes Pump Max °F Approx. Volume Lab setting In-tank
785A Yes No Yes No 212 1 Gal. w/ container Yes Yes
785B  No Yes Yes No 360 1 Gal. w/ container Yes Yes
785C Yes  No No No 212 1/2 Gal. Yes No
800L Yes  No No Yes 212 1 Gal. Yes No
800PVC  No Yes No No 360 1 Gal. Yes No
492  No Yes  Yes  No 180 400 Milliliters Yes Yes


The PN:  800L Plating Cell has two compartments and are specifically designed for precision deposit stress measurements and is to be used in a laboratory.  A dividing wall separates the cells into two equal sections.  The dividing wall has flow holes between the two compartments to permit the solution to flow through both sections (Size 8.5″ x 9.25″ x 7.75″). One section is for using the Immersion Heater (PN:3046) and agitation by using the Submersible Pump (PN: 404 *Note: Once the pump is used it is to be stored in water). This cell offers a standard geometry with respect to anode size and positioning.  Consistent anode to cathode spacing is maintained.

NOTE: During plating a test strip is exposed to a uniform current density along the legs of the strip.  The plating test should be continued until the test strip legs deflect up to 20 units and with a target thickness that does not exceed approximately 100 microinches for the most accurate results.  Very low stress may show only 1-2 units.

*NOTE: This cell is not to be used with Chrome solutions.

Plating Cell Features:

* Made of Poly-carbonate (which is NOT recommended for Chrome plating)

* Is a self contained unit for Lab work

* Two anode pockets for 2 3/8″ (61 mm) x 2 3/8″ (61 mm) size anodes

* Leads to each anode from a central contact

* Is a divided Cell with two compartments with flow holes between the compartments (one for PN:  3046 Immersion Heater and PN:  404 Submersible Pump, and the other one for plating the test strip)

* PN: 404 Submersible Pump is included with the purchase of a PN:  800L Plating Cell.

* A clip assembly for positioning the test strip midway between the anodes.


Additional information

Weight 7 lbs
Dimensions 9 x 8 x 7 in