Temperature Controller Prewired


The Temperature Controller Pre-wired is used to maintain a uniform bath temperature.

SKU: TC590 Category:


The Temperature Controller pre-wired is for automatic control of the temperature in a plating solution selected for internal deposit stress tests within a ± 3°F range, simply plug the plating solution heating source, a Magnet Stir / Hot Plate or an Immersion Heater, into the Electronic Temperature Controller and plug the input of the Electronic Temperature Controller into a 120 Volt source.

Features of the Electronic Temperature Temperature Controller:

Keyboard programming of set point temperature -40 to 212°F (-40 to 100°C)

User- selectable Fahrenheit/Celsius scales

Differential Range 1°F to 30°F (1 to 30°C)

Supply Voltage 120 VAC, 60Hz

Power Consumption 1.8 VA Maximum

SPST Output Relay Contacts Electrical Ratings:
– Full Load Amperes N.O. 12A
– Locked Rotor Amperes N.O. 72A
– Non-inductive Amperes N.O.
– Pilot Duty: 125 VA @ 120 VAC

Sensor Type PTC Sensor with 6.6 ft (2.0) leads

Programming Steps and Display instructions are included.

Made in Mexico.

Additional information

Weight 4 lbs
Dimensions 10 x 9 x 7 in

You may also like…