All You Need
In One Single
Theme.
Lorem ipsum dolor sit amet, consectetuer adipiscing elit, sed diam nonummy nibh euismod tincidunt ut laoreet dolore magna aliquam erat
Search here:

Products

PN: 800L Plating Cell

$445.00

PN: 800L Plating Cell Poly-carbonate (Two Compartment). The Poly-carbonate cell is not suited for high alkalyne plating baths.

 

Photo Credit: Athena Marie Photography
http://www.athenamariephotography.com

SKU: 800L Category:

Description

Cell P/N Lexan PVC Flow Holes Pump Max °F Approx. Volume Lab setting In-tank
785A Yes No Yes No 212 1 Gal. w/ container Yes Yes
785B No Yes Yes No 360 1 Gal. w/ container Yes Yes
785C Yes No No No 212 1/2 Gal. Yes No
800L Yes No No Yes 212 1 Gal. Yes No
800PVC No Yes No No 360 1 Gal. Yes No
492 No Yes Yes No 180 400 Milliliters Yes Yes

The PN:  800L Plating Cell has two compartments and are specifically designed for precision deposit stress measurements and is to be used in a laboratory.  A dividing wall separates the cells into two equal sections.  The dividing wall has flow holes between the two compartments to permit the solution to flow through both sections (Total Size 8.5″Length x 9.25″Width x 7.75″Height including handle- without the handle the height is 4.25″). One section is for using the Immersion Heater (PN:3046) and agitation by using the Submersible Pump (PN: 404 *Note: Once the pump is used it is to be stored in water). This cell offers a standard geometry with respect to anode size and positioning.  Consistent anode to cathode spacing is maintained.

NOTE: During plating a test strip is exposed to a uniform current density along the legs of the strip.  The plating test should be continued until the test strip legs deflect up to 20 units and with a target thickness that does not exceed approximately 100 microinches for the most accurate results.  Very low stress may show only 1-2 units.

*NOTE: This cell is not to be used with Chrome solutions.

Plating Cell Features:

  • Made of Poly-carbonate (which is NOT recommended for Chrome plating)
  • Is a self contained unit for Lab work
  • Two anode pockets for 2 3/8″ (61 mm) x 2 3/8″ (61 mm) size anodes
  • Leads to each anode from a central contact
  • Is a divided Cell with two compartments with flow holes between the compartments (one for PN:  3046 Immersion Heater and PN:  404 Submersible Pump, and the other one for plating the test strip)
  • PN: 404 Submersible Pump is included with the purchase of a PN:  800L Plating Cell
  • A clip assembly for positioning the test strip midway between the anodes

Pump included Features:

  • Flow Rate: 80 GPH
  • Max head: 22″
  • Adjustable flow rate (knob Adjustment)
  • Power: 2.7W
  • Outlet: .5″
  • Dimensions: 1.75″ X 1.75″ X 1.25″

Additional information

Weight 7 lbs
Dimensions 9 × 8 × 7 in